Blogger Notes

"Smoothening, Tracing and  Cutting"

The smoothening

After the instructions of madam Florendo, we started to give a shot to our project by smoothening our 'PCB' using sand paper and eraser.After that, we covered our 'PCB' with masking tapes and put on the xeroxed design and a carbon paper on top of it for our design to be transferred to the masking tape. As said, we are tasked to transfer the xeroxed design to the masking tape.

Aprille tracing

                                        Aprille tracing for some minutes.

Me cutting

                    Then,  I'm tasked to cut the excess of the traced design  that is not needed so that the design of the 'PCB' will be illustrated clearly.

The design PCB

                                                         The Designed PCB